Water Slide Instructions

Lush Glitter and Blanks Water-Slide Instructions

 

1 – Spray a clear topcoat over the image (White Knight Crystal Clear Acrylic Spray is recommended and available at Bunnings) to seal the water-slide.

 

2 – Let dry for at least an 15 minutes

 

3 – Repeat above 2 steps – let dry for at least an hour

 

4 – Cut out image with your scissors - rounding the edges will ensure the image does not peal off as easily as sharp corners

 

5 – Place in a bowl of water for about 15 - 40 seconds (until image slides away easily from backing paper) The water-slide will more than likely curl up and this is normal – just move it around gently so that all area of the water-slide gets covered in water. The decal is ready to be transferred when you see the edges peeling from the backing sheet and it moves easily on the backing paper

 

6 - Quickly position the water-slide on your project. Position decal, backing side down and gently slide backing off by pushing it down away from water-slide. Keep the backing flush with your project as you gently pull it out from behind the decal. Press firmly, use your fingers, a damp cloth/ paper towel or a mini squeegee to remove air bubbles. Take you time with this step as its important to have no air bubbles as this may lift your water-slide later.

 

7 – Let dry for at least 24 hours to completely dry out.

 

All water slides are non refundable and you are agreeing when purchasing that you acknowledge that any application errors are the responsibility of buyer/crafter.   No water slides will be replaced - no exceptions.